Bosch LSU4.2 Wideband Replacement Oxygen O2 sensor for PLX Innovate LM-1 LC-1

Description

Store Categories
Store Categories
US WAREHOUSE
TPMS SENSOR
OXYGEN SENSOR
others
Fuel Injector
Pressure Sensor
Spark Plugs
PDC Parking Sensor
CA WAREHOUSE
TIRE PRESSURE SENSOR
For GM Parts
TPMS Sensors
Oxygen Sensors
Parking Aid Sensor
Fuel Injector
Spark Plugs
Pressue Sensor
Others
Oil Filter Adapter
Fuel Injection Pressure Sensor
For Ford Parts
TPMS Sensors
Oxygen Sensor
Fuel Injectors
Parking Aid Sensor
Fuel Pressure Sensor
Spark Plugs
For Honda Parts
TPMS Sensors
Oxygen Sensor
Fuel Injectors
For Toyota Parts
TPMS Sensors
Oxygen Sensor
For Kia Parts
TPMS Sensor
Dodge Parts
TPMS Sensor
FCA Fuel Control Accuator
Camera
For Mazda Parts
TPMS Sensors
Fuel Rail Pressure Sensor
For Nissian Parts
TPMS Sensor
Oil Filter Adapter
Oxygen Sensor
PRESSURE SENSOR
For Infiniti Parts
TPMS Sensor
Oxygen sensor
For Mecedes-Benz Parts
TPMS Sensor
NOX Sensor
Fuel Rail Pressure Sensor
Oxygen Sensor
For Hyundai Parts
TPMS Sensor
FUEL PRESSURE
For Subraru Parts
TPMS Sensors
Oxygen Sensor
For Mitsubishi
TPMS Sensor
For Audi Parts
TPMS Sensor
Fuel Rail Pressure Sensor
Oxygen Sensor
For Volkswagen Parts
TPMS Sensor
Oxygen sensor
Flex Fuel Sensor
Fuel Rail Pressure Sensor
For Dodge Parts
TPMS Sensors
Oil Filter Adapter
Fuel Injection Regulator
Parking Aid Sensor
Nitrogen Sensor
Manifold Pressure Sensor
Oxygen Sensor
Camera
For Cummins Parts
Pressure Sensor
Nitrogen Sensor
For Citroën Parts
Fuel Rail Pressure Sensor
For BMW Parts
Parking Sensors
Oxygen Sensors
Fuel Rail Pressure Sensors
NOX Sensor
TPMS Sensor
For Renault Parts
Fuel Rail Pressure Sensor
For Volvo Parts
TPMS Sensors
FUEL PRESSURE
For Isuzu Parts
NOX Sensor
Fuel Pressure Regulator
For Opel
LAMBDA O2 SENSOR
PRESSURE SENSOR
Other
Bosch LSU4.2 Wideband Replacement Oxygen O2 sensor for PLX Innovate LM-1 LC-1
Product Description
17014 AFR Upstream LSU4.2 Wide-Band O2 Oxygen Sensor
For 99-05 VW Jetta 1.8L-L4
Bosch 4.2LSU Wideband
This is the replacement O2 sensor for the PLX, as well as the Innovate Systems (LM-1 or LC-1). However this can be a simple replacement for certain applications stock wideband O2 sensor.
This is a
5-wire sensor
that reads oxygen in the same way as your typical O2 sensor, however it employs the latest “planar” onstruction with a special two-part sensing element to measure how much oxygen is in the exhaust. The Bosch LSU 4 wideband oxygen sensor has a response time of less than 100 milliseconds to changes in the air/fuel mixture, and reaches operating temperatures of 700 to 800 degree Centigrade within 20 seconds or less with it’s built-in heater. This is about twice the operating temperature of a regular oxygen sensor.
This is the Bosch LSU 4.2 5 wire heated O2 sensor.
Bosch Part # 17014
Innovate Part # 3737
SPECIFICATION :
Condition:
New OEM
Manufacturer Part Number:
0258007057,17014
Other Part Number:
0 258 007 057 / 17 014 / 0258007351 0 258 007 351
234-5115, 24321, 213-3894
234-5117,1K0998262D, 5S4260, SU6316, SU6322
PACKAGE CONTENT :
1PCS Oxygen Sensor
Symptoms of a Bad Oxygen Sensor
#1 –
Check engine light on
,
Code checker identifying O2 sensor failure .
You can diagnose the problem yourself if you have access to the right tools OBD2 diagnostic tool. O2 Sensor Codes include P0030, P0031, P0036, P0037, P0130, P0131, P0132, P0133, P0134, and P0135.
#2 –
A rotten egg odor emitting from the exhaust.
#3 –
A reduction in fuel economy.
#4 –
Your catalytic converter fails unexpectedly.
#5 –
Exhaust emissions reach undesirable levels.
#6 –
Your engine surges, hesitates, skips and bucks.
NOTE:
Please check the picture and the part number carefully to make sure that you bought the right part for your car.The only way to be 100% sure that the part will fit your vehicle is to check your original part,You can also email us before purchasing, we will check for you and reply soon within 24 hours.
Q&A
Q:
Why does the oxygen sensor have false alarm, after installation ?
A:
The clearing of the errors can be obtained on most systems when the vehicle battery is disconnected for at least 60 seconds. The assignment of the new sensor parameters is done automatically when the errors are cleared, but in some systems a short adapting tour is required. In this case the vehicle has to be driven on the road for some 10-15 minutes, in order to have the ECU adapt itself to the new sensor.
Q:
How do I know the O2 sensor is good or not ?
A:
The only way to know if the O2 sensor is functioning normally is to check its responsiveness to changes in the air/fuel mixture, by Voltage Measurement or Waveform Simulation.
Q
：
How should I install oxygen sensor ?
A:
The following is the installation instructions: Use the correct part number as listed in the application catalogue ,Do not use sensor if i has been dropped ,Remove protection cap just prior to installation;
Firstly install sensor body ensuring lead wire is not twisted or bent , Do not use impact wrench or socket type wrench to install sensor ,M18 sensors - install finger tight then 1/2-3/4 turn with a wrench (35-45Nm) ;
Then connect and route lead wire as originally installed , Do not allow lead wire to touch exhaust manifold or any other hot component ,Do not apply any substances (especially oil or grease) to connector sensor ,Do not use leaded fuels,silicone or metal based additives.
Q:
When should replace the oxygen sensor?
A:
Oxygen Sensor Failure Symptoms:
Reduced fuel mileage
Failed emissions testing
A check engine light
Poor drive-ability
Shipping & Handling %
Return Policy%
Contact us %
We Can Help%
Shipping & Handling %
● Should you be worrying about how your order would be sent after the payment was done. As so, your order is already taken in process of packaging by a specialist, who knows his/her job pretty well, in our warehouse. Anyways, the order will be sent in
1 business days
,
and after
2 to 5 business days
,
you should be able to meet your package.
● Our prior shipping carrier is
USPS or FedEx
,
according to the product.
Your tracking number
,
which will show up in your message as package sent, should keep you reassuring while you play with it. If any suspicious information is spotted, please break in and let us know! We are eager to help, otherwise it gives us an illusion of nothing going wrong.
Return Policy%
No worry, just make sure that day is in
30 days
after item received and go to Open-A-Return. In this case, you may wonder about the return shipping cost. We, too, wonder that one. Thus the rule is while no mistake is proved to be made by the Seller in the transaction, the Buyer will be responsible for the Return Label Cost.
By the way, please forgive us refusing any return request in which the order is 31 days old or even older.
Contact us %
Customer Service got fired if they don't work things out with you, so knock their door at will. If any question came in mind, please felt free to contact us through Messages. We will respond in 24 hours. There shall be nothing to worry about as we have confidence to solve your issue.
We Can Help%
For a presumably defective product received, this one would be a bit tricky. Please tell us where the problem occurs, and our Customer Service and Technical Department will work it through with you.
Pictures and videos can come in handy here.
* For any confusing or false description in the listing that causes a mis-purchase, please kindly remind us so we can improve our listings and continuously offer a better purchasing experience to you and to all our customers as well. Did it occur to be our mistake for the faulty transaction, we would be responsible for the return cost.
We wish you understand the pressures here, and our effort will always come to your aid.
Copyright © 2018 Dianxiaomi