Second Skin Audio Damplifier Deadening Mats | 20 Sqft | 10 Sheets | FREE SHIP

Description

New Second Skin Audio Damplifier Deadening Mat 20Sqft
10 Sheets!
Damplifier mats were designed to outperform other popular sound deadening materials, while saving our customers money. With premium butyl rubber, a thicker foil constraint layer, and comparable overall thickness to other top brands’ flagship product, Damplifier premium rubber mats are the best value on the market. We’ve done the research. Deaden metal and kill structural vibrations, noise, and heat with the best value in sound deadening.
High temperature butyl rubber adhesive – insist on more rubber and less filler!
Ultra-thick, annealed black foil with a ghosted logo
1mm total thickness (40 mils)
Each sheet is 12” x 24” (2 sq ft) and weighs about 0.35 lbs / sq ft
Thermal range: -75 F to 450 F – will not melt, out gas, or fall off
Deadens any sheet metal, aluminum, or prepared fiberglass
Made in the USA
Say NO to asphalt! Say NO to rolls of roofing materials! Insist on premium Second Skin products for your vehicle.
Product Usage
We recommend wearing gloves while handling Damplifier. The edges are sharp due to the foil.
While you can apply Damplifier with just your hands, you’ll make the job much easier by using a heavy duty hand roller.
Recommended Install Locations
Doors - outer and inner door skin
Floor - front firewall all the way back to the rear deck seat wall
Firewall - cabin or engine side
Trunk - floor, walls, lid, and spare tire area
Roof - front windshield to back windshield
Hood - entire lid
Pillars - A, B, and C
Application Instructions
After upholstery or carpet is out, remove loose debris, rust, dirt, and waxy oils to insure a solid contact surface.
Cut Damplifier to the desired size with a sharp utility knife. USE CAUTION as the foil edges are very sharp.
Peel the wax paper liner from the back of Damplifier and adhere the tacky butyl side to the sheet metal. Slowly work the Damplifier Pro onto the panel with a hand roller, ensuring that there are no air pockets between the applications.
You need a minimum of 25% coverage on the metal to deaden it, but we generally recommend at least 60% coverage to get 95% of the results. Many customers choose to cover 100% to also get the full benefits of Damplifier as a thermal insulator.